ST RM0316 GPIO/SYSCFG/EXTI reference:
https://www.st.com/st-web-ui/static/active/en/resource/technical/document/reference_manual/DM00043574.pdf
DS9118Rev14 pin table:
https://www.st.com/resource/en/datasheet/stm32f303cb.pdf
BoardV2.0 visually checked for PA3 button R17=0Ohm R2=10kOhm C2=100nF and PB6 NPN LED:
https://gebrabit.com/wp-content/uploads/2024/07/GebraBit-STM32F303-Schematic-V2.0.pdf
Pinned HAL953955afe65f89e60e556bbcdba752597f5da65d GPIO_Init configures EXTICR/RTSR/FTSR/IMR. HAL EXTI handler checks pending then W1C clears before callback. Actual source hashes in manifest. No physical edge or bounce count measured.


## Inspected official STM32CubeF3 V1.11.6 examples
Projects/STM32F3-Discovery/Examples/GPIO/GPIO_EXTI/Src/main.c
https://github.com/STMicroelectronics/STM32CubeF3/blob/663d2baae3604244f90ed80d0d757df17e36ada9/Projects/STM32F3-Discovery/Examples/GPIO/GPIO_EXTI/Src/main.c
Projects/STM32F3-Discovery/Examples/GPIO/GPIO_EXTI/Src/stm32f3xx_it.c
https://github.com/STMicroelectronics/STM32CubeF3/blob/663d2baae3604244f90ed80d0d757df17e36ada9/Projects/STM32F3-Discovery/Examples/GPIO/GPIO_EXTI/Src/stm32f3xx_it.c
Relevant source snippets were actually inspected. The official GPIO example uses Discovery PA0 with a rising edge and a busy-loop debounce. This lesson adapts the HAL IRQ/callback route to the onboard PA3 active-LOW button, both edges and deferred20ms main-loop qualification. Board-specific BSP mappings and the original blocking callback were not copied.
