http://www.openzwave.com/device-database/031E:000d:0001 images/inovelli/lzw31-sn.png https://products.z-wavealliance.org/products/3723 https://inovelli.com/shop/smart-sensors/z-wave-4-in-1-sensor/ https://inovelli.com/shop/smart-sensors/z-wave-4-in-1-sensor/ To Exclude your switch, put your HUB in exclusion mode and press the Sensor Button on the back of the device one (1) time. U.S. / Canada / Mexico https://products.z-wavealliance.org/ProductManual/File?folder=&filename=product_documents/3723/Inovelli%204-1%20Sensor%20Manual.pdf Control and Monitor Temperature, Light, Motion, and Humidity with the 4 in 1 Sensor. LZW60 4-in-1 Sensor LZW60 To include your switch, start the inclusion process on your HUB and Sensor Button on the back of the device one (1) time. Initial Release Value at which the sensor reports low battery to the gateway Range:10-50 Default: 10 Change the sensitivity of the PIR (Motion) Sensor 0 = off, 1 = Low sensitivity, 10 = High sensitivity Default: 8 The amount of seconds between motion detection (ie: the interval) Range:5-15300 Default: 30 Should Basic Set Command be sent after PIR is triggered? This is used to turn other devices on/off when motion is detected. Default: No Ability to reverse the Basic Set behavior for devices associated in group 2 Default: ON when motion is tripped, OFF when motion stops The interval in which the temperature sensor is checked, in seconds. Set to 0 to disable (Note: will be rounded to the nearest minute) Default: 7200 (2 hours) The interval in which the humidity sensor is checked, in seconds. Set to 0 to disable (Note: will be rounded to the nearest minute) Default: 7200 (2 hours) The interval in which the luminance sensor is checked, in seconds. Set to 0 to disable (Note: will be rounded to the nearest minute) Default: 7200 (2 hours) The interval in which the battery level is checked, in seconds. Set to 0 to disable (Note: will be rounded to the nearest minute) Default: 86400 (24 hours) Sensor reports are only checked at the interval defined in parameters 101-104. Should the sensor data always be reported, or only if the value has changed more than the threshold configured in parameters 111-114? Always: Send sensor data every interval, even if the value did not change. Threshold: Send sensor data on interval, but only if the value has changed by more than the defined threshold since the last report was sent. Default: Always Set the temperature threshold of the sensor. If Sensor Report Method = "Threshold", the temperature change must exceed this value in order to be reported to the hub. Range: 1-500 1 = 0.1 degrees Celcius, 500 = 50 degrees Celcuis Default: 10 (1 degree Celcuis) Set the humidity threshold of the sensor. If Sensor Report Method = "Threshold", the humidity change must exceed this value in order to be reported to the hub. Range: 1-32, 1 = 1%, 32 = 32% Default: 5% Set the luminance threshold of the sensor (in lux). If Sensor Report Method = "Threshold", the luminance change must exceed this value in order to be reported to the hub. Range: 1-65528 Default: 150 Set the battery threshold of the sensor (percent). If Sensor Report Method = "Threshold", the battery level change must exceed this value in order to be reported to the hub. Range: 1-100 Default: 10