TITLE Dead Air Receiver PROMPT Create an abandoned AM radio with three surviving test transmissions from the fictional station WREN. Use a soot enamel case #191715, amber phosphor #f3c77c and oxidized copper #a86643. Let a giant frequency readout dominate the left of the fascia and put a scope in a recessed oval on the right. Beneath them give the tuning slider a full-width etched dial, then add a compact log in Courier and an engraved sound toggle. Allow the viewer to tune through 530–1700 kHz. Away from a signal show dense jitter. Near 730, 1080 or 1490 kHz let the waveform thin to keyed pulses and the call letters print into the scope. Give the three invented transmissions intimate station copy: a handover at the bridge, a weather notice and a signoff. Use a quiet filtered oscillator only after sound is enabled and silence it when out of band. Draw the traces on a high-DPI canvas and offer a still frame under reduced motion. On phones place the readout above the scope without losing the front-panel proportions. DESCRIPTION An amber radio front panel holds the last three scraps of audio from an invented station. A little change in frequency can mean the difference between a jumble of static and a legible call sign. VISUAL TECHNIQUES Canvas scope with triggered Morse waveforms CSS engraved scales and enamel casing Web Audio tone gated by a keyed signal INTERACTION MODEL Move the tuner to sample a frequency. Enable the speaker to hear the keyed carrier while on a transmission.