-- Scale, resolution and arrangement are set from the monitor panel in the top -- bar, as are refresh rate and rotation, and saved for each monitor in -- ~/.local/state/omarchy/monitors/settings. This file is for what the panel -- doesn't cover, and it loads after Omarchy's defaults. A choice made in the -- panel still wins for that monitor, unless the panel's choices are switched -- off below. -- -- See https://wiki.hypr.land/Configuring/Basics/Monitors/ -- List current monitors and supported resolutions with: hyprctl monitors all -- Ignore the monitor panel's saved choices, so this file alone sets every -- monitor, such as to keep the same setup in your dotfiles across machines. -- The panel's changes then last only until Hyprland reloads. With the panel -- off, match a monitor by its description rather than the port it's in: -- hl.monitor({ output = "desc:Dell Inc. DELL U2723QE", mode = "preferred", position = "auto", scale = 1.5 }) -- omarchy_monitor_panel_settings = false -- Scale every monitor without a choice of its own (Omarchy picks "auto"). -- hl.monitor({ output = "", mode = "preferred", position = "auto", scale = 1.6 }) -- GTK and XWayland scale, a whole number (Omarchy sets 2 until a scale is -- chosen in the panel, then follows the lowest monitor scale). -- hl.env("GDK_SCALE", "1") -- Keep a monitor off, such as the phantom output an Apple 6K XDR can show. -- hl.monitor({ output = "DP-3", disabled = true }) -- Run a mode the panel doesn't offer: a resolution below 1080p or of another -- shape, a fast rate at a resolution other than the current one, or a scale -- outside its presets. -- hl.monitor({ output = "DP-2", mode = "2560x1440@144", position = "auto", scale = 1.5 }) -- 10-bit color. -- hl.monitor({ output = "DP-2", mode = "preferred", position = "auto", scale = 1, bitdepth = 10 }) -- Variable refresh rate (0 = off, 1 = always, 2 = fullscreen only). -- hl.config({ misc = { vrr = 0 } })