#### ALL FULL DEFINITIONS PARAMETERS ####



#### ALL GENERATED DEFINITIONS PARAMETERS ####
AFM enabled
AFM maximum voltage error enabled(Off=2047,On=1002)
AFM maximum voltage
AFM minimum voltage
Calibration ID
Cold start idle air control system (P050A, P050B)
Coolant thermostat temperature check enabled (P0128) #3
Default PA value
EGR enabled
EVAP leak detection enabled (P0455 P0456 P0457) #1
Ignition dwell angle voltage compensation
Mass or volume circuit range performance problem enabled (P0101)
Maximum MAP voltage
Maximum plate deviation (P2101)
Minimum ECT for alternator control
Minimum MAP voltage
Misfire detection
Overrun cutoff MAP high cam (cut)
Overrun cutoff MAP high cam (recover)
Overrun cutoff MAP low cam (cut)
Overrun cutoff MAP low cam (recover)
Overrun fuel cut delay
P1009 VTC over advanced error threshold angle
PA vs MAP error enabled (P2227)
Purge/EVAP enabled
Rev limiter #1
Rev limiter recover #1
RSSWGO67
Second ECT sensor enabled
Secondary oxygen sensor enabled
Short term fuel trim minimum
TPlate Normal (US)
Use MAP to determine WOT(Off=1,On=0)
VTC enabled
VTEC disengage minimum speed
VTEC engage minimum speed
VTEC minimum coolant temperature
VTEC oil pressure switch enabled
Water temperature ignition retard