#### ALL FULL DEFINITIONS PARAMETERS ####



#### ALL GENERATED DEFINITIONS PARAMETERS ####
Air temperature fuel compensation cranking
Calibration ID
Closed loop target lambda limit
Cranking (batch mode) fuel direct ratio
Cranking (batch mode) wall deposit ratio
Cranking (seq mode) fuel direct ratio
Cranking (seq mode) wall deposit ratio
EGR enabled
ELD enabled
EPS enabled
Forced induction enabled
High speed throttle reduction speed
Ignition dwell angle voltage compensation
Knock retard high
Knock retard low
Knock sensitivity high
Knock sensitivity low
KWOT high
KWOT low
LAF voltage to lambda
Launch rpm #1
Launch rpm #2
Launch rpm recover #1
Launch rpm recover #2
Maximum plate deviation (P2101)
PA sensor enabled
Primary oxygen sensor enabled
Purge/EVAP enabled
Rev limiter #1
Rev limiter #2
Rev limiter #3
Rev limiter #4
Rev limiter recover #1
Rev limiter recover #2
Rev limiter recover #3
Rev limiter recover #4
Secondary oxygen sensor enabled
Speed limiter rpm
Speed limiter speed
Use MAP to determine WOT(Off=1,On=0)
VSA enabled
VTEC oil pressure switch enabled
Water temperature ignition compensation hot high
Water temperature ignition retard
WOT lambda adjustment high #1
WOT lambda adjustment high (cat protect)
WOT lambda adjustment high (regular)
WOT lambda adjustment low (cat protect)
WOT lambda adjustment low (regular)