-- MIB created 5/12/100 12:18:57, by
--   SMIC (the next generation) version 1.6.29, November 22, 1994.

CISCO-L2L3-INTERFACE-CONFIG-MIB DEFINITIONS ::= BEGIN

-- From file: "CISCO-L2L3-INTERFACE-CONFIG-MIB.my"

IMPORTS
    OBJECT-TYPE
            FROM RFC-1212
    ifIndex
            FROM IF-MIB
    ciscoMgmt
            FROM CISCO-SMI;

ciscoL2L3IfConfigMIB OBJECT IDENTIFIER ::= { ciscoMgmt 151 }
-- MODULE-IDENTITY
--  LastUpdated
--    200005101900Z
--  OrgName
--    Cisco Systems, Inc.
--  ContactInfo
--    Cisco Systems
--    Customer Service
--    
--    Postal: 170 W Tasman Drive
--            San Jose, CA  95134
--            USA
--    
--    Tel: +1 800 553-NETS
--    
--    E-mail: cs-snmp@cisco.com
--  Descr
--    Interface switchport mode configuration management MIB.
--    
--    This MIB is used to monitor and control 
--    configuration of interface switchport and routed mode.
--  RevDate
--    200005101900Z
--  RevDescr
--    Initial version of this MIB module.

ciscoL2L3IfConfigMIBObjects OBJECT IDENTIFIER ::= { ciscoL2L3IfConfigMIB 1 }
cL2L3IfConfig   OBJECT IDENTIFIER ::= { ciscoL2L3IfConfigMIBObjects 1 }
ciscoL2L3IfConfigMIBConformance OBJECT IDENTIFIER ::= { ciscoL2L3IfConfigMIB 3 }
ciscoL2L3IfConfigMIBCompliances OBJECT IDENTIFIER ::= { ciscoL2L3IfConfigMIBConformance 1 }
ciscoL2L3IfConfigMIBGroups OBJECT IDENTIFIER ::= { ciscoL2L3IfConfigMIBConformance 2 }

CL2L3InterfaceMode ::= INTEGER {
        routed(1),
        switchport(2)
        }
-- TEXTUAL-CONVENTION
--  Status
--    mandatory
--  Descr
--    The operational mode of the interface.
--    
--    For administrative and operational states, valid values are: 
--    routed(1), switchport(2).
--    
--    routed(1): Routed mode interfaces direct traffic using 
--    layer 3 protocols.
--    
--    switchport(2):  Switchport-mode interfaces direct traffic using 
--    layer 2 protocols.  A switchport-mode interface can be in
--    access mode, or trunk mode, or multi-mode.
--    
--    Switchport interface operating mode can be configured manually,
--    or negotiated by Dynamic Trunking Protocol (DTP) or Dynamic 
--    Inter-Switch Link (DISL).
--    
--    Access-mode interfaces carry one VLAN's traffic.  Access-mode
--    interface parameters are configured in CISCO-VLAN-MEMBERSHIP-MIB.
--    
--    Trunk-mode interfaces carry one or more VLANs.  VLAN-related 
--    trunk-mode interface parameters are configured in CISCO-VTP-MIB.
--    
--    Multi-mode interfaces carry one VLAN to each alias of a 
--    single connected end-station.  VLAN-related multi-mode 
--    interface parameters are configured in CISCO-VTP-MIB.

cL2L3IfTable OBJECT-TYPE
    SYNTAX SEQUENCE OF CL2L3IfEntry
    ACCESS not-accessible
    STATUS mandatory
    DESCRIPTION
        "The table shows the administratively requested and
        actual operating configuration for switchport interfaces."
    ::= { cL2L3IfConfig 1 }

cL2L3IfEntry OBJECT-TYPE
    SYNTAX CL2L3IfEntry
    ACCESS not-accessible
    STATUS mandatory
    DESCRIPTION
        "An entry represents the configuration and operation of a
        switchport interface.
        
        Entries are created and deleted automatically in tandem 
        with the corresponding ifEntries."
    INDEX { ifIndex }
    ::= { cL2L3IfTable 1 }

CL2L3IfEntry ::= SEQUENCE {
    cL2L3IfModeAdmin CL2L3InterfaceMode,
    cL2L3IfModeOper CL2L3InterfaceMode
    }

cL2L3IfModeAdmin OBJECT-TYPE
    SYNTAX CL2L3InterfaceMode
--    Rsyntax INTEGER {
--        routed(1),
--        switchport(2)
--        }
    ACCESS read-write
    STATUS mandatory
    DESCRIPTION
        "The administratively desired interface mode."
    ::= { cL2L3IfEntry 1 }

cL2L3IfModeOper OBJECT-TYPE
    SYNTAX CL2L3InterfaceMode
--    Rsyntax INTEGER {
--        routed(1),
--        switchport(2)
--        }
    ACCESS read-only
    STATUS mandatory
    DESCRIPTION
        "The operational interface mode."
    ::= { cL2L3IfEntry 2 }

ciscoL2L3IfConfigMIBGroup OBJECT IDENTIFIER ::= { ciscoL2L3IfConfigMIBGroups 1 }
-- OBJECT-GROUP
--  Status
--    mandatory
--  Descr
--    Interface L2 & L3 mode objects
--  objects
--    cL2L3IfModeAdmin, cL2L3IfModeOper

ciscoL2L3IfConfigMIBCompliance OBJECT IDENTIFIER ::= { ciscoL2L3IfConfigMIBCompliances 1 }
-- MODULE-COMPLIANCE
--  Status
--    mandatory
--  Descr
--    The compliance statement for entities which implement
--     the Cisco L2L3 Interface Configuration Management MIB
--  Module
--    >>current<<
--   MandGroup
--    ciscoL2L3IfConfigMIBGroup


END