############################## Client and Server ##############################
# [Required] Working mode, "client" or "server"
mode = "client"

# [Required] The address for communication between the client and the server.
# Server only supports ws and needs to provide wss through an external web
# service. Client supports ws and wss.
websocket = "wss://canets.org"

# [Optional] Password used to verify identity
# Only the hashed content of the password and timestamp is transmitted on the
# network, and the password cannot be obtained from the message.
#password = "this is the password"

# [Optional] Show debug log
#debug = false

# [Optional] Restart interval
# When an internal exception is detected, the service will be automatically
# restarted. When configured to 0, the process will exit without restarting.
# Otherwise, it will restart after an interval of n seconds.
#restart = 0

# [Optional] Set NTP Server
# The time difference between the client and the server should not exceed 30
# seconds. If the local time is inaccurate, the current real time can be
# obtained from the NTP server.
ntp = "pool.ntp.org"

################################# Server Only #################################
# [Optional] The range of addresses automatically assigned by the server
# Server address allocation is not enabled by default, and the client needs to
# configure a static address through tun.
#dhcp = "192.168.202.0/24"

# [Optional] software-defined wide area network
# IP packets entering 192.168.202.1/32 with the destination address 172.17.0.0/16
# will be forwarded to 192.168.202.2. Multiple rules are separated by semicolons.
# Extraneous whitespace characters are prohibited.
#sdwan = "192.168.202.1/32,172.17.0.0/16,192.168.202.2;192.168.202.2/32,172.16.0.0/16,192.168.202.1"

################################# Client Only #################################
# [Optional] Network interface name
# Used to differentiate networks when running multiple clients.
#name = ""

# [Optional] Static address
# If dhcp is not configured, tun must be configured. When there is an address
# conflict, the previous client will be kicked out.
#tun = "192.168.202.1/24"

# [Optional] STUN server address
# If the STUN server is not configured, P2P will be disabled.
stun = "stun://stun.canets.org"

# [Optional] Active discovery interval
# Periodically sends broadcasts to try to establish P2P with devices on the
# network. The default configuration is 0, which means disabled.
discovery = 300

# [Optional] The cost of routing through this machine
# Use all nodes in the network to establish the link with the lowest latency.
# This configuration represents the cost of using this node as a relay. The
# default configuration is 0 which means disabled.
route = 5

# [Optional] Local UDP port used for P2P
# The default configuration is 0, which means it is allocated by the operating
# system. This configuration can be used when the firewall is strict and can
# only open specific ports.
#port = 0

# [Optional] Local IPv4 address used for peering connections
# By default the IPv4 address of the local physical network card will be
# detected. When there are multiple physical network cards, the detection
# results may not be the best. You can specify it manually.
#localhost = "127.0.0.1"

# [Optional] Number of worker threads
# Default is 0 means no independent worker threads are enabled
#workers=0

# [Optional] Maximum Transmission Unit
#mtu=1400