-- This file was included in WWP MIB release 04-10-01-0027 -- -- CIENA-CES-RSVPTE-MIB.my -- CIENA-CES-RSVPTE-MIB DEFINITIONS ::= BEGIN IMPORTS TimeTicks, Integer32, Unsigned32, IpAddress, OBJECT-TYPE, MODULE-IDENTITY FROM SNMPv2-SMI DisplayString, MacAddress, RowStatus, TruthValue, TEXTUAL-CONVENTION FROM SNMPv2-TC CienaGlobalState FROM CIENA-TC cienaCesConfig,cienaCesNotifications FROM CIENA-SMI; cienaCesRsvpteMIB MODULE-IDENTITY LAST-UPDATED "201102020000Z" ORGANIZATION "Ciena, Inc" CONTACT-INFO " Mib Meister 115 North Sullivan Road Spokane Valley, WA 99037 USA Phone: +1 509 242 9000 Email: support@ciena.com" DESCRIPTION "This MIB module is for the RSVP-TE configuration for MPLS tunnels" REVISION "201102020000Z" DESCRIPTION "Initial version." ::= { cienaCesConfig 16 } -- -- Textual convention -- AdvertisedLabel ::= TEXTUAL-CONVENTION STATUS current DESCRIPTION "Advertised Label" SYNTAX INTEGER { implicitnull(1), nonreserved(99) } RsvpOperStatus ::= TEXTUAL-CONVENTION STATUS current DESCRIPTION "The current operational state of RSVP-TE." SYNTAX INTEGER { operStatusUp(1), -- active operStatusDown(2), -- inactive operStatusGoingUp(3), -- activating operStatusGoingDown(4),-- deactivating operStatusActFailed(5) -- activation failed } -- -- Node definitions -- cienaCesRsvpteMIBObjects OBJECT IDENTIFIER ::= { cienaCesRsvpteMIB 1 } cienaCesRsvpteObjects OBJECT IDENTIFIER ::= { cienaCesRsvpteMIBObjects 1 } cienaCesRsvpte OBJECT IDENTIFIER ::= { cienaCesRsvpteMIBObjects 2 } cienaCesRsvpteAdminStatus OBJECT-TYPE SYNTAX CienaGlobalState MAX-ACCESS read-only STATUS current DESCRIPTION "The desired administrative state of RSVP-TE." ::= { cienaCesRsvpteObjects 1 } cienaCesRsvpteOperStatus OBJECT-TYPE SYNTAX RsvpOperStatus MAX-ACCESS read-only STATUS current DESCRIPTION "The current operational state of RSVP-TE." ::= { cienaCesRsvpteObjects 2 } cienaCesRsvpteRetryInterval OBJECT-TYPE SYNTAX Unsigned32 (3..65) UNITS "seconds" MAX-ACCESS read-only STATUS current DESCRIPTION "The persistent tunnel retry interval. This is the interval between the first failure of a persistent tunnel and the first attempt to re-establish the tunnel. This cannot be changed while admin status is enable or oper status is up" DEFVAL { 3 } ::= { cienaCesRsvpteObjects 3 } cienaCesRsvpteRetryInfiniteState OBJECT-TYPE SYNTAX INTEGER { on(1), off(2) } MAX-ACCESS read-only STATUS current DESCRIPTION "The persistent tunnel retry infinity. This is the State which when on will trigger RSVP-TE to try to restore the tunnels infinite times. This object can only be set if RSVP-TE is globally disabled." DEFVAL { on } ::= { cienaCesRsvpteObjects 4 } cienaCesRsvpteRetryMax OBJECT-TYPE SYNTAX INTEGER (1..255) MAX-ACCESS read-only STATUS current DESCRIPTION "The maximum number of retry attempts that will be made before a persistent tunnel is deemed inoperable. Once in this state, a management agent should set mplsTunnelAdminStatus to 'up' to attempt to reestablish the tunnel. This field is not used when cienaCesRsvpteRetryInfiniteState is on " DEFVAL { 10 } ::= { cienaCesRsvpteObjects 5 } cienaCesRsvpteRefreshInterval OBJECT-TYPE SYNTAX Integer32 UNITS "milliseconds" MAX-ACCESS read-only STATUS current DESCRIPTION "This RSVP-TE value, R, which is used to set the average interval between refresh path and resv messages." DEFVAL { 30000 } ::= { cienaCesRsvpteObjects 6 } cienaCesRsvpteRefreshMultiple OBJECT-TYPE SYNTAX Integer32 (1..214783647) MAX-ACCESS read-only STATUS current DESCRIPTION "The RSVP-TE value, K, which is the number of unresponded Path or Resv refresh attempts which must be made, spaced by the refresh interval before the state is deemed to have timed out." DEFVAL { 3 } ::= { cienaCesRsvpteObjects 7 } cienaCesRsvpteRefreshSlewDenominator OBJECT-TYPE SYNTAX Integer32 (1..214783647) MAX-ACCESS read-only STATUS current DESCRIPTION "The denominator of the fraction, SlewMax, which is the maximum allowable increase in the refresh interval, R, to prevent state timeout while changing R. R is increased by this fraction until it reaches the new desired value." DEFVAL { 10 } ::= { cienaCesRsvpteObjects 8 } cienaCesRsvpteRefreshSlewNumerator OBJECT-TYPE SYNTAX Integer32 (1..214783647) MAX-ACCESS read-only STATUS current DESCRIPTION "The numerator of the fraction, SlewMax, which is the maximum allowable increase in the refresh interval, R, to prevent state timeout while changing R. R is increased by this fraction until it reaches the new desired value." DEFVAL { 3 } ::= { cienaCesRsvpteObjects 9 } cienaCesRsvpteBlockadeMultiple OBJECT-TYPE SYNTAX Integer32 (1..214783647) MAX-ACCESS read-only STATUS current DESCRIPTION "The RSVP-TE value, Kb, which is the number of refresh timeout periods after which blockade state is deleted." DEFVAL { 2 } ::= { cienaCesRsvpteObjects 10 } cienaCesRsvpteLSPSetupPriority OBJECT-TYPE SYNTAX Integer32 (0..7) MAX-ACCESS read-only STATUS current DESCRIPTION "The setup priority to apply to LSPs which are not signalling this parameter. 0 represents the highest priority, 7 the lowest. The value of this object must be numerically more or equal (so lower or equal priority) than the value of the holding priority object." DEFVAL { 4 } ::= { cienaCesRsvpteObjects 11 } cienaCesRsvpteLSPHoldingPriority OBJECT-TYPE SYNTAX Integer32 (0..7) MAX-ACCESS read-only STATUS current DESCRIPTION "The holding priority to apply to LSPs which are not signalling this parameter. 0 represents the highest priority, 7 the lowest. The value of this object must be numerically less or equal (so higher or equal priority) than the value of the holding priority object." DEFVAL { 3 } ::= { cienaCesRsvpteObjects 12 } cienaCesRsvpteUseHopByHop OBJECT-TYPE SYNTAX TruthValue MAX-ACCESS read-only STATUS current DESCRIPTION "A flag to indicate that RSVP-TE should use the hop by hop addressing scheme for PATH and PATH-TEAR messages it sends. If set then the IP addresses used in the IP header of PATH messages forwarded by RSVP-TE set source as the local outgoing interface IP address, and destination as the next hop router IP address." DEFVAL { false } ::= { cienaCesRsvpteObjects 13 } cienaCesRsvpteRestartCapable OBJECT-TYPE SYNTAX TruthValue MAX-ACCESS read-only STATUS current DESCRIPTION "A flag to indicate whether the local node should advertise itself as restart capable." DEFVAL { true } ::= { cienaCesRsvpteObjects 14 } cienaCesRsvpteRestartTime OBJECT-TYPE SYNTAX Unsigned32 MAX-ACCESS read-only STATUS current DESCRIPTION "The time in milliseconds that the local node takes to restart RSVP-TE and the communication channel used for RSVP-TE communication. This is advertised to neighbors in the Restart_Cap object in Hello messages. Only used if cienaCesRsvpteRestartCapable is set to true." DEFVAL { 10000 } ::= { cienaCesRsvpteObjects 15 } cienaCesRsvpteRecoveryTime OBJECT-TYPE SYNTAX Unsigned32 MAX-ACCESS read-only STATUS current DESCRIPTION "The period of time in milliseconds that the local node would like neighbors to take to resyncronize RSVP-TE and MPLS forwarding information after the re-establishment of Hello connectivity. This is advertised to neighbors in the Restart_Cap object in Hello messages. A value of zero indicates that the node does not support resynchronization following failure of the local node. A value of 0xFFFFFFFF indicates an infinite recovery time. Only used if cienaCesRsvpteRestartCapable is set to true." DEFVAL { 0 } ::= { cienaCesRsvpteObjects 16 } cienaCesRsvpteMinPeerRestart OBJECT-TYPE SYNTAX Integer32 MAX-ACCESS read-only STATUS current DESCRIPTION "The mininum period of time in milliseconds that RSVP-TE should wait for a restart capable neighbor to regain Hello connectivity before invoking procedures related to communication loss. RSVP-TE will wait for the maximum of this time and the restart_time advertised in the RESTART_CAP object in Hello messages from the neighbor." DEFVAL { 0 } ::= { cienaCesRsvpteObjects 17 } cienaCesRsvpteIfTable OBJECT-TYPE SYNTAX SEQUENCE OF CienaCesRsvpteIfEntry MAX-ACCESS not-accessible STATUS current DESCRIPTION "A table of interfaces that RSVP-TE can be enabled on." ::= { cienaCesRsvpte 1 } cienaCesRsvpteIfEntry OBJECT-TYPE SYNTAX CienaCesRsvpteIfEntry MAX-ACCESS not-accessible STATUS current DESCRIPTION "CIENA Descr." INDEX { cienaCesRsvpteIfIndex } ::= { cienaCesRsvpteIfTable 1 } CienaCesRsvpteIfEntry ::= SEQUENCE { cienaCesRsvpteIfIndex INTEGER, cienaCesRsvpteIfName OCTET STRING, cienaCesRsvpteIfIpAddr IpAddress, cienaCesRsvpteIfMtu INTEGER, cienaCesRsvpteIfAdminStatus CienaGlobalState, cienaCesRsvpteIfOperStatus INTEGER, cienaCesRsvpteIfHelloInterval Unsigned32, cienaCesRsvpteIfHelloTolerance Unsigned32, cienaCesRsvpteIfAdvertisedLabel AdvertisedLabel } cienaCesRsvpteIfIndex OBJECT-TYPE SYNTAX INTEGER (1..4096) MAX-ACCESS not-accessible STATUS current DESCRIPTION "Interface Index" ::= { cienaCesRsvpteIfEntry 1 } cienaCesRsvpteIfName OBJECT-TYPE SYNTAX OCTET STRING (SIZE (0..32)) MAX-ACCESS read-only STATUS current DESCRIPTION "Interface Name" ::= { cienaCesRsvpteIfEntry 2 } cienaCesRsvpteIfIpAddr OBJECT-TYPE SYNTAX IpAddress MAX-ACCESS read-only STATUS current DESCRIPTION "Interface IP Address" ::= { cienaCesRsvpteIfEntry 3 } cienaCesRsvpteIfAdminStatus OBJECT-TYPE SYNTAX CienaGlobalState MAX-ACCESS read-only STATUS current DESCRIPTION "Desired RSVP-TE status on this Interface" ::= { cienaCesRsvpteIfEntry 4 } cienaCesRsvpteIfOperStatus OBJECT-TYPE SYNTAX INTEGER { up(1), down(2) } MAX-ACCESS read-only STATUS current DESCRIPTION "RSVP-TE Operational Status on this Interface" ::= { cienaCesRsvpteIfEntry 5 } cienaCesRsvpteIfHelloInterval OBJECT-TYPE SYNTAX Unsigned32 (0..30) UNITS "seconds" MAX-ACCESS read-only STATUS current DESCRIPTION "RSVP-TE hello message interval. " DEFVAL { 0 } ::= { cienaCesRsvpteIfEntry 6 } cienaCesRsvpteIfHelloTolerance OBJECT-TYPE SYNTAX Unsigned32 (0..10) MAX-ACCESS read-only STATUS current DESCRIPTION "RSVP-TE hello tolerance defines number of hello interval which may pass without receiving a successful Hello message from a partner before the Hello session times out." DEFVAL { 3 } ::= { cienaCesRsvpteIfEntry 7 } cienaCesRsvpteIfAdvertisedLabel OBJECT-TYPE SYNTAX AdvertisedLabel MAX-ACCESS read-only STATUS current DESCRIPTION "This attribute decides what kind of a Label will be advertised by RSVP-TE for a Label Request received on this L3 Interface" DEFVAL { 99 } ::= { cienaCesRsvpteIfEntry 8 } END -- -- CIENA-CES-RSVPTE-MIB --