# VISCA color correction Adjust a camera's white balance from the Cameras pane without changing the configuration. The screenshots show the application with simulated camera data. ## Supported cameras Configure the camera as `viscaoverip` with its address and raw VISCA UDP port. No additional configuration setting is needed. Color correction is independent of `tallyMode`. The application checks support by reading white-balance mode, red gain and blue gain. The color-wheel button appears only after all three inquiries return valid settings. The LANC camera types do not offer these controls. See [camera compatibility](CameraCompatibility.md) for tested cameras and the [VISCA command reference](https://support.avonic.com/support/solutions/articles/80001153827-visca) for white-balance and gain commands. ## Open the popover Expand **Cameras**, then click the color wheel beside the camera you want to adjust. Rows without color correction keep an empty wheel slot so camera movement status stays aligned. The address in the popover identifies the camera receiving the commands. Its pointer aims at that camera's button, including when the popover changes sides or shifts to fit the screen. ![Cameras pane with a color wheel beside the supported VISCA camera and no wheel beside the LANC camera](images/camera-color-pane.png) Click outside the popover or press **Escape** to close it. Closing does not undo adjustments. Keyboard camera controls pause while it is open, and any held keyboard movement is released. Game controllers remain active. ## One-push white balance 1. Point the camera at a white reference under the lighting you will use. 2. Click **One-push white balance**. The application selects one-push mode, waits for completion, then sends its trigger. 3. Wait for the camera to complete the command and for the settings to reload. One-push measures white balance once. It does not enable continuous automatic white balance. To return to automatic white balance, turn **Manual white balance** on and then off. ## Manual corrections Enable **Manual white balance**, then adjust **Red gain** and **Blue gain**. Increasing red gain adds red; increasing blue gain adds blue. Each slider accepts whole values from **0 to 255**. The number beside it shows the selected value. ![Color-correction popover with one-push white balance, manual red and blue gain sliders, and a pointer to its camera button](images/camera-color-popover.png) Changes queue immediately. Each color command waits for the previous one to complete; movement controls remain active. There is no Apply or Save button. Turning manual white balance off restores automatic white balance, which can change the balance again as the lighting changes. The panel reads settings when opened, after white-balance completion, and after a refused color command. Readback waits for pending color commands. A refresh requested during readback starts a fresh read afterward; the obsolete results stay hidden. If an acknowledged color command has no completion after five seconds, the application drops pending corrections and reads current settings without replaying the action. Controls are disabled until readback finishes; gain sliders require manual white balance. If settings become unavailable during an adjustment, the panel disables the affected controls and rereads the camera. These settings belong to the camera, not the configuration file. Whether they survive a camera restart depends on the camera. ## If controls are missing or unavailable If no color wheel appears, check the camera's connection, VISCA port and support for the three inquiries. A connected camera can still lack color correction. Select **ViscaOverIpCamera** in the log to see refused commands, unsupported inquiries and timeouts. A timed-out white-balance action is not automatically replayed. Transient inquiry refusals are retried; unanswered inquiries time out. Movement stops take priority over queued color commands. Raw VISCA replies have no request identifier. A delayed reply can be mistaken for a newer inquiry of the same shape or a command on a reused socket. Close and reopen the popover to read settings again if values look stale or after a failed operation.