# This is a complete sdb configuration template which is always kept updated # to include all the configuration options. I encourage you to always use this # when you use a configuration file # Instead of deleting entire sections from this file, comment them out, so that you # now what you've kept enabled and what you've kept disabled. This helps avoid # configuration problems during production # This is a *REQUIRED* key [server] host = "127.0.0.1" # The IP address to which you want sdb to bind to port = 2003 # The port to which you want sdb to bind to noart = false # Set `noart` to true if you want to disable terminal artwork maxcon = 50000 # set the maximum number of clients that the server can accept mode = "dev" # Set this to `prod` when you're running in production and `dev` when in development # This is an optional key [auth] # the origin key to be used to claim the root account origin_key = "4527387f92a381cbe804593f33991d327d456a97" # This key is *OPTIONAL* [bgsave] # Run `BGSAVE` `every` seconds. For example, setting this to 60 will cause BGSAVE to run # after every 2 minutes enabled = true every = 120 # This key is *OPTIONAL* [snapshot] every = 3600 # Make a snapshot after every 1 hour (60min * 60sec= 3600secs) atmost = 4 # Keep the 4 most recent snapshots failsafe = true # stops accepting writes if snapshotting fails # This key is *OPTIONAL*, used for TLS/SSL config [ssl] key = "/path/to/keyfile.pem" chain = "/path/to/chain.pem" port = 2004 only = true # optional to enable SSL-only requests passin = "/path/to/cert/passphrase.txt" # optional to programmatically verify the TLS cert