# #######
# Logging
# #######
log:
  # loglevel to use. Supported are critical, error, warning, info and debug. Default is warning.
  level: warning
  # The size in MB of a logfile. Default is 10 (MB).
  #size: 10
  # The number of logfiles which should be kept. Default is 3.
  #count: 3

# #############
# MQTT Settings
# #############
mqtt:
  # Hostname or IP of the MQTT broker
  host: 192.168.1.1
  # Port of the MQTT broker. Normally 1883 or 8883 (TLS)
  port: 1883
  # Basictopic to use to publish the values
  base_topic: s0pcmreader
  # Username and password required to connect to the MQTT broker
  #username: s0pcmreader
  #password: password
  # If a client id should be used, if not configured - a random value will be used
  #client_id: <random>
  # If messages should have the retain flag. Default it is yes.
  #retain: yes
  # If values should be send per topic, or combine them into a json string as much as possible
  #split_topic: yes

  # TLSv1/1.1/1.2 Configuration
  # Enable TLS, without a "tls_ca" it still connects, but no certificate verification is done.
  #tls: yes
  # Optional certificate to check against.
  #tls_ca: CA.pem
  # Default we check if the hostname/IP returned matches our certificate.
  #tls_check_peer: yes
  # Retry interval in seconds, if a connection to the MQTT broker fails. If an IP address is not reachable, it could take longer to reconnect.
  #connect_retry: 5

# ###################
# SerialPort Settings
# ###################
serial:
  # the serialport to which the pulse counter is connected to
  port: /dev/ttyACM0
  # The baudrate of the serial device. Default is 9600.
  #baudrate: 9600
  #parity:
  #stopbits:
  #bytesize: 7
  #timeout: None
  #connect_retry: 5

# ##############
# S0PCM Settings
# ##############
s0pcm:
  # The MQTT publish interval. If not configured, it will publish on every S0PCM packet.
  # This value shouldn't be configured lower then 10 seconds (default pulse counter interval).
  # Default is to follow the S0PCM packet interval (10 seconds).
  #publish_interval: 10
  # If only changes should be published. Default is yes.
  # NOTE: This is disabled when 'split_topic=no' is configured.
  #publish_onchange: yes

  # If enabled, which input should be counted/used, all other ones are ignored.
  # Default is all available inputs.
  #include:
  #  - 1
  #  - 2

  # If enabled, the daily counters will be written to a CSV file named "daily-<input>.txt"
  # Default is disabled.
  #dailystat:
  #  - 1
  #  - 2

# End